Technical data
90362-01 Using the Setup Utility 3-7
4.
When the ADSP connection is established, you should see the
NetBlazer’s login prompt. Log in as
setup
to run the NetBlazer
Setup Utility. Refer to “Starting the Setup Utility” on page 3-7 for
instructions on using the Setup Utility.
Dial-in Connection to Remote NetBlazer
You can use a dial-in connection to configure a NetBlazer at a remote site
by performing the following steps:
1.
Make sure that the remote NetBlazer is set up and ready to accept a
telephone call.
2.
Use a communications program on your computer to make a modem
connection with the remote NetBlazer.
3.
When the connection is established, you should see the NetBlazer’s
login prompt. Log in as
setup
to run the NetBlazer Setup Utility.
Refer to the following section, “Starting the Setup Utility,” for
instructions on using the Setup Utility.
Starting the Setup Utility
To use the Setup Utility to configure your NetBlazer, follow these steps:
1. Fill in the Worksheets in Appendix B. Ask your service provider or
System Administrator for the necessary information.
Remote
Network
NetBlazer LS
Modem Modem