Technical data

90362-01 NetBlazer and LAN Setup 4-11
1. Select seed for an interface and press Enter to see the AppleTalk
Seed Router screen:
Figure 4-6. The AppleTalk Seed Router Screen
2.
If you are configuring an
en
interface, you see a
Begin range
field;
type a network number from 1 to 65,279 for the beginning of the
range. For information on ranges, see Appendix E, “AppleTalk
Routing,” or Apple Computer’s Inside Macintosh .
3.
If you see an
End range
field, type a network number from 1 to
65,279 for the end of the range. This number must be the same or a
higher number than what you typed for
Begin range
.
4.
If you are configuring an
lt
interface, you see a
Network number
field, and you should type a single network number between 1 and
65,279 for the entire range.
AppleTalk Seed Router NetBlazer Setup Utility V3.0
Configure AppleTalk Seed router for lt0. Changes to this screen
do not take effect until you return to the previous screen.
Previous
Cancel
Help
Network number: 0
New zone: <<ZONE>>
ZONES DEFINED
Type a new zone name, then press Enter