Technical data

5-2 Line Setup 90362-01
4. Move to the line you want to configure and press Enter.
You see the Line Details screen for that line:
Figure 5-2. The Line Details Screen
5.
For the
Modem or TA
field, if the NetBlazer detects a modem or TA
on the line and fills in a name for this field, leave this field set as
prompted.
6. For the Type field, you can set the line to be either a sync line or an
async
line. The default is
async
. You might set the current line to
sync, for example, if you want to set up a Frame Relay interface on
this line.
7.
Leave the
Speed
field set to the automatically detected speed. The
speed of the line and the speed of the connecting device should
match. If the two speeds do not match, it causes communications
problems.
Note:
You may be disconnected if you attempt to configure a line while connected
to it.
Line Details NetBlazer Setup Utility V3.0
Make any changes to the configuration details for Line line01,
then move to Reset line and press Enter to set the changes.
Previous
Help
Return to Main Menu
Modem or TA: <<None>>
Type: async
Speed: 9600
Autoconfigure: off
Login: on
Note: <<None>>
Reset line no
Press Enter to return to the previous screen
Note:
If your modem or TA is not automatically identified by the NetBlazer, you
need to set
Autoconfigure
to
config
, type the modem name in the
Modem or
TA
field, and then change
Reset
to
yes
.