Technical data

90362-01 Line Setup 5-3
If you need to change the speed, press the Spacebar to select a speed.
Async lines can be set to one of the following speeds:
300
,
1200
,
2400
,
4800
,
9600
,
19700
,
38400
,
57600
,
115200
. Sync lines can be set
to either 56000 or 64000 .
8.
For
Autoconfigure
, you can select
on
,
off
, or
config
. If you select
on
,
the NetBlazer automatically identifies the modem or TA type and
sets the line up accordingly. Selecting
off turns off the automatic de-
tection and configuration. Selecting
config
tells the NetBlazer to
take whatever modem or TA you type in the
Modem or TA
field as
the modem to use. The NetBlazer then sets the line up for that mo-
dem and uses that modem’s modemcap settings in configuring the
line.
9. The Login field tells the NetBlazer whether or not a connection on
this line should see a login prompt. Select
on
to have the NetBlazer
display a login prompt on this line, or
off
to have the NetBlazer not
show a prompt.
10.
In the
Note
field you can type a comment or description about the
configuration. For example, you might type the phone number of the
modem on the line.
11.
Set the
Reset line
field to
yes
to reset the line once you make a
change. For example, if you had set up a line to be a sync line to run
Frame Relay and later want to use the line for asynchronous commu-
nications, you need to set
Reset line
to
yes
after you change the
setting for
Type
.
Once you are done configuring the line, you can configure the applications
you want for the line (such as Frame Relay or ISDN).
Note:
When you set up a dedicated connection, the NetBlazer automatically turns
off the login prompt. If you later decide to use that line for something other
than dedicated point-to-point communications, you need to use this field to
manually turn the login prompt back on.