Technical data

7-10 Dial-up Connections 90362-01

To set the Protocol details for your interface, follow these steps.

Display the Protocol Details screen:

Figure 7-5. The Protocol Details Screen

Check to see if the remote network has configured a connection for

your NetBlazer. Until the remote network has been set up for your

connection, the settings on this screen and the IP screens cannot take

effect.

Note:

If you are creating a dial backup connection, you

do not

want to set the

Protocol details since the backup interface inherits all routes from the

interface it is backing up.

Also, you only need to set the protocol details for the primary interface of a

set of balanced interfaces.

The worksheets to use for dedicated interfaces are listed on page 8-4.

Protocol Details: ruby NetBlazer Setup Utility V3.0

For IPX or AppleTalk, first make sure that the remote NetBlazer is

configured to allow a connection through this interface. Then, enable

the protocol and select its Learn function. For IP select IP routes.

IP routes

Enable IPX no

Learn IPX routes

Forget IPX routes

Enable AppleTalk no

Learn AppleTalk routes

Forget AppleTalk routes

Help

Return to Main Menu

Press Enter to return to the previous screen