Technical data

8-2 Dedicated Connections 90362-01

If your dedicated connection will need a dial backup, you should create a

dial-up interface to use as this backup before creating the dedicated inter-

face; see Chapter 7, "Dial-up Connections" for more information. Note that

the dial backup

must

have the same name as the remote NetBlazer.

To configure the NetBlazer for dedicated LAN-to-LAN connections, follow

these steps on both sides of the link.

Establish a connection to your NetBlazer as described on page 3-3.

On the Main Menu screen, select

Dedicated LAN-to-LAN

The Dedicated LAN-to-LAN screen appears.

Figure 8-2. The Dedicated LAN-to-LAN Screen

Dedicated LAN-to-LAN NetBlazer Setup Utility V3.0

Set up dedicated LAN-to-LAN connections. Press Enter on an existing

interface to change it. Type a new name for any line to create a new

dedicated link. Type "frame" to set up a Frame Relay connection.

Help

Return to Main Menu

# DEVICE INTERFACE (modem etc.)

001 line00 -console

002 line01 -

Press Enter to return to the previous screen