Technical data

90362-01 Dedicated Connections 8-5
8. If you want to set up a dial backup for this line (to be used if the
dedicated line goes down), type the name of a previously configured
dial-up connection in
Dial backup
. If you type a name that does not
match the list of dial-up interfaces set for this NetBlazer, you get an
error message. Remember, you must select
PPP
for
Framing type
in
order to use a dial-up backup for a dedicated interface.
9. Once you have configured the NetBlazer at the other end of the
dedicated connection up to this same point, the
Enable interface
field
should automatically change to
Yes
to enable the currently selected
interface. The NetBlazer only allows this setting to be changed if the
other end of the connection has also been configured. Change this
field to
No
if you do not want the currently selected interface to be
enabled.
Setting Frame Relay Connections
You can use Worksheet 15, the “Frame Relay Connections” worksheet on
page B-18 to record and organize the information necessary to complete the
tasks in this section.
To set up a dedicated frame relay LAN-to-LAN connection:
1.
If necessary, change one of the asynchronous lines to a synchronous
line; see Chapter 5, “Line Setup” for information on changing the
line type.