Specifications

DHCP Pool Command Set Command Reference Guide

DHCP POOL COMMAND SET

To activate the DHCP Pool command set, enter the ip dhcp-server pool command at the Global

Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

ip dhcp-server pool MyPool

Router(config-dhcp)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

do on page 558

end on page 559

exit on page 560

All other commands for this command set are described in this section in alphabetical order.

client-identifier <identifier> on page 241

client-name <name> on page 243

default-router <address> <secondary> on page 244

dns-server <address> <secondary> on page 245

domain-name <domain> on page 246

hardware-address <hardware-address> <type> on page 247

host <address> [<subnet mask> or <prefix length>] on page 249

lease <days> <hours> <minutes> on page 250

netbios-name-server <address> <secondary> on page 251

netbios-node-type <type> on page 252

network <address> [<subnet mask> or <prefix length>] on page 253