Specifications

Command Reference Guide SHDSL Interface Configuration Command Set

SHDSL INTERFACE CONFIGURATION COMMAND SET

To activate the SHDSL Interface Configuration command set, enter the interface shdsl command at the

Global Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface shdsl 1/1

Router(config-shdsl 1/1)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 556

description on page 557

do on page 558

end on page 559

exit on page 560

shutdown on page 561

All other commands for this command set are described in this section in alphabetical order.

alarm-threshold [loop-attenuation | snr-margin] on page 370

boot alternate-image on page 371

equipment-type [co | cpe ] on page 372

inband-detection on page 373

inband-protocol on page 374

linerate <value> on page 375

loopback network on page 376

loopback remote on page 377

outage-retrain on page 378

snmp trap on page 379

snmp trap link-status on page 380

test-pattern on page 381