Modem Installation And Maintenance Practice
Table Of Contents
- Total Access 1240 Installation and Maintenance Practice
- Front Matter
- Section 1, Introduction
- Section 2, Application Guidelines
- Section 3, Installation
- Section 4, Provisioning Defaults
- Section 5, User Interface
- Introduction
- System Management
- Logging on to the Total Access 1240
- Menu Structure
- Menu Navigation
- Menu Trees
- Menu Descriptions
- Configuration Screen
- Bridge Circuit Management Menu
- System Management Menu
- SHDSL Ports Menu
- System Alarm Log Screen
- Contact Information Screen
- Section 6, Maintenance
- Section 7, Specifications
- Appendix A, Declaration of Conformity
- Appendix B, SCA File Format
- Appendix C, Warranty
Section 5, User Interface - Logging on to the Total Access 1240
61179605L5-5B 5-3
LOGGING ON TO THE TOTAL ACCESS 1240
To login to the Total Access 1240 system, perform the following steps:
1. Establish the physical connection to the Total Access 1240.
2. If a craft port session is being used, proceed to step 3. If using a Telnet session proceed to
step 4.
3. Press
CTRL+R until the Login prompt appears.
The Login screen is displayed in Figure 5-2. The Total Access 1240 system requires the
login name and associated password.
4. Enter the default login name, “ADMIN” (or the configured login name with System
Administrator privileges), and press
ENTER.
5. Enter the default password, “PASSWORD” (or the configured password), and press
ENTER.
Figure 5-2. Login Screen
NOTE
The Login name and Password fields are case sensitive. The default
values are all uppercase. For more information, refer to “Password
Control Menu” on page 5-36.
Total Access 1240 - IPoE Fed
Login: ADMIN
Password: ********