Total Access User Interface Guide

Page 30 © 2002, ADTRAN, Inc. 64200600L1#T-31A
Total Access 600R User Interface Guide (UIG)
To support these transfers, ADTRAN delivers a TFTP program with the Total Access 600R called TFTP Server. You
can configure any PC running Microsoft Windows with this software, and store a configuration file.
Only one configuration transfer session (upload or download) can be active at a time.
Displays the method used to transfer the configuration file to or from a server.
XMODEM
and
TFTP
are supported.
SYSTEM UTILITY>CONFIG TRANSFER>TRANSFER TYPE
Only
B
INARY
transfers are currently supported from this menu.
SYSTEM UTILITY>CONFIG TRANSFER>TFTP SERVER IP ADDRESS
Specifies the IP address of the TFTP server. Get this number from your system administrator. If using the ADTRAN
Utilities TFTP server, this number appears in the TFTP server status window. The factory default value is
0.0.0.0.
SYSTEM UTILITY>CONFIG TRANSFER>TFTP SERVER FILENAME
Defines the name of the configuration file that you transfer to or retrieve from the TFTP server. The default name is
ta600.cfg
, but you can edit this name.
SYSTEM UTILITY>CONFIG TRANSFER>CURRENT TRANSFER STATUS
Indicates the current status of the update.
SYSTEM UTILITY>CONFIG TRANSFER>PREVIOUS TRANSFER STATUS
Indicates the status of the previous update.
SYSTEM UTILITY>CONFIG TRANSFER>LOAD AND USE CONFIG
Retrieves the configuration file specified in the
TFTP S
ERVER
F
ILENAME
field from the server. To start this command,
enter
Y
to begin or enter
N
to cancel.
SYSTEM UTILITY>CONFIG TRANSFER>SAVE CONFIG REMOTELY
Saves the configuration file specified in
TFTP S
ERVER
F
ILENAME
to the server identified in
TFTP S
ERVER
IP A
DDRESS
.
To start this command, enter
Y
to begin or enter
N
to cancel.
Before using the TFTP method for
C
ONFIG
T
RANSFER
, the Total Access 600R should have a valid IP
address, subnet mask, and default gateway (if required).
If you execute this command, the Total Access 600R retrieves the configuration file, reboots, then
restarts using the new configuration.
Before using this command, you must have identified a valid TFTP server in
TFTP S
ERVER
IP A
DDRESS
.