User Manual
Table Of Contents
- System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- 1. Navigating the Terminal Menu
- 2. Terminal Menu and System Control
- 3. Menu Descriptions
- >TRACER System Status
- >Main Menu
- >TRACER System Configuration
- >TRACER Link Performance History
- >T1A Status/Configuration/Loopback
- >T1A Performance History
- >T1B Status/Configuration/Loopback
- >T1B Performance History
- >T1C Status/Configuration/Loopback
- >T1C Performance History
- >T1D Status/Configuration/Loopback
- >T1D Performance History
- Troubleshooting Guide
Section 5, User Interface Guide TRACER 4206 System Manual
46 © 2002 ADTRAN, Inc. 612804206L1-1B
>TRACER SYSTEM CONFIGURATION
Figure 4 shows the TRACER System Configuration menu page. System configuration parameters for both
the local and remote TRACER 4106/4206 units are available through this menu page.
Figure 4. TRACER System Configuration
>TRACER SYSTEM CONFIGURATION > RX POWER
Displays the approximate receiver levels (for both the local and remote units) using a series of symbols (#).
The more symbols (
#) displayed, the stronger the signal. If the link is down and remote end data is
unavailable,
D
ATA
N
OT
A
VAILABLE
is displayed in place of the symbols (#). This parameter is display only.
>TRACER SYSTEM CONFIGURATION > TX POWER
Allows the transmitter levels (for both the local and remote units) to be adjusted. The current transmitter
level is displayed using a series of symbols (
#). The more symbols (#) displayed, the stronger the signal. If
the link is down and remote end data is unavailable,
D
ATA
N
OT
A
VAILABLE
is displayed in place of the
symbols (
#).
Press <C> from any menu in the TRACER 4106/4206 VT100 menu structure to access the
TRACER System Configuration menu page.
Reducing the transmitter power of the remote TRACER 4106/4206 could negatively impact
the TRACER RF link.