User Manual
Table Of Contents
- System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- 1. Navigating the Terminal Menu
- 2. Terminal Menu and System Control
- 3. Menu Descriptions
- >TRACER System Status
- >Main Menu
- >TRACER System Configuration
- >TRACER Link Performance History
- >T1A Status/Configuration/Loopback
- >T1A Performance History
- >T1B Status/Configuration/Loopback
- >T1B Performance History
- >T1C Status/Configuration/Loopback
- >T1C Performance History
- >T1D Status/Configuration/Loopback
- >T1D Performance History
- Troubleshooting Guide
TRACER 4206 System Manual Section 5, User Interface Guide
612804206L1-1B © 2002 ADTRAN, Inc. 47
>TRACER SYSTEM CONFIGURATION > SITE NAME
Enter up to 25 alphanumeric characters to be displayed for identification of the TRACER 4106/4206
system.
>TRACER SYSTEM CONFIGURATION > RF BANDPLAN
Sets the bandplan for the TRACER 4106/4206. Each channel is divided into three bandplans (1, 2, or 3).
Both local and remote TRACER 4106/4206 must be configured with the same bandplan (1, 2, or 3) but
different channel plans (Plan A or Plan B). For example, the transmitter at one end of the link will transmit
in bandplan 1 of channel A (the lower portion of the spectrum) and receive in bandplan 1 of channel B (the
upper portion). Consequently, the receiver at the other end should receive in bandplan 1 of channel A (the
lower portion) and transmit in bandplan 1 of channel B (the upper portion). (Refer to Figure 5 and Figure
6.). The TRACER 4106/4206 comes factory programmed with RF bandplan set to Band 1.
Figure 5. 2.4 GHz Bandwidth Division (TRACER 4106)
Figure 6. 5.8 GHz Bandwidth Division (TRACER 4206)
Channel A
2416 2441.752422 24282400 MHz 2483.5 MHz
Bandplan 3
Bandplan 2
Bandplan 1
Channel B
2456 2462 2468
Bandplan 3
Bandplan 2
Bandplan 1
Channel A
57345725 5787 58505744 5753MHz MHz
Bandplan 3Bandplan 2Bandplan 1
Channel B
5814 5824 5833
Bandplan 3Bandplan 2Bandplan 1