User Manual
Table Of Contents
- System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- 1. Navigating the Terminal Menu
- 2. Terminal Menu and System Control
- 3. Menu Descriptions
- >TRACER System Status
- >Main Menu
- >TRACER System Configuration
- >TRACER Link Performance History
- >T1A Status/Configuration/Loopback
- >T1A Performance History
- >T1B Status/Configuration/Loopback
- >T1B Performance History
- >T1C Status/Configuration/Loopback
- >T1C Performance History
- >T1D Status/Configuration/Loopback
- >T1D Performance History
- Troubleshooting Guide
Section 5, User Interface Guide TRACER 4206 System Manual
48 © 2002 ADTRAN, Inc. 612804206L1-1B
>TRACER SYSTEM CONFIGURATION > MODEM CONTROL
Configures the modem control leads on the RS-232 port (terminal interface located on the rear panel of the
unit). Set
M
ODEM
C
ONTROL
to E
NABLED
when connecting the unit to a modem (using a null modem
adapter). Setting
M
ODEM
C
ONTROL
to D
ISABLED
prevents the TRACER 4106/4206 from monitoring DCD
and enables data to be sent to the VT 100 continuously.
M
ODEM
C
ONTROL
must be set to D
ISABLED
when the
VT100 terminal is in use. The TRACER 4106/4206 comes factory programmed with
M
ODEM
C
ONTROL
set
to
D
ISABLED
.
>TRACER SYSTEM CONFIGURATION > MODEM CONNECTION (LOGOUT)
Activator to cause the TRACER 4106/4206 to de-assert Clear To Send (CTS) and DSR for a time greater
than 20 milliseconds. This signals the modem to disconnect the analog connection. Hangup-On-DTR-Drop
may need to be explicitly enabled on some modems. If
P
ASSWORD
P
ROTECTION
is E
NABLED
, this menu also
causes the unit to close the current session and return to the TRACER System Status menu page and wait
for password input.
>TRACER SYSTEM CONFIGURATION > PASSWORD ENABLE
Configures password protection for the VT100 terminal interface. Password protection for the TRACER
4106/4206 requires password input from the TRACER System Status menu page when connecting to the
unit. When configured for Password protection, the TRACER 4106/4206 closes any terminal session that
remains inactive for more than 10 minutes. The TRACER 4106/4206 comes factory programmed with
P
ASSWORD
E
NABLE
set to D
ISABLED
.
>TRACER SYSTEM CONFIGURATION > PASSWORD
Sets the password for password protection of the TRACER 4106/4206 VT100 terminal interface. Enter up
to 8 alphanumeric characters. The system password is case sensitive.
>TRACER SYSTEM CONFIGURATION > PERFORMANCE STATS (CLEAR)
Activator to reset all system error counters for the TRACER 4106/4206.
Press <Ctrl+Z> three times from the terminal interface to temporarily disable
M
ODEM
C
ONTROL
when the modem control leads are active.
The default password for the TRACER 4106/4206 is tracer.