User Manual
Table Of Contents
- Trademarks
- About this Manual
- Federal Communications Commission Radio Frequency Interference Statement
- Warranty and Customer Service
- Customer Service, Product Support Information, and Training
- 4205 System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- Troubleshooting Guide
Section 4, Network Turnup Procedure TRACER 4205 System Manual
34 © 2002 ADTRAN, Inc. 612804205L1-1A
1. INTRODUCTION
This section discusses the installation process of the TRACER 4205 system.
2. TOOLS REQUIRED
The tools required for the installation of the TRACER 4205 are:
• VT100 terminal or PC with terminal emulation software
• RS-232 (DB-25 male for TRACER 4205 end) cable for connecting to terminal
3. UNPACK AND INSPECT THE SYSTEM
Each TRACER 4205 is shipped in its own cardboard shipping carton. Open each carton carefully and
avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in
transit, immediately file a claim with the carrier, then contact ADTRAN Customer Service (see Warranty
and Customer Service information in the front of this manual).
Contents of ADTRAN Shipment
Your ADTRAN shipment includes the following items:
• TRACER 4205 unit
• TRACER 4205 Documentation CD
Customer Provides
The following items are necessary for the installation of the TRACER 4205 system and are not provided
by ADTRAN:
• 21 to 63 VDC power source (or AC adapter available from ADTRAN P/N 1280650L1), either polarity
referenced to ground
• Antenna and mounting hardware
• Antenna feedline cable
• DS3 cables (BNC for TRACER 4205 end) for connecting to DS3 equipment
Changes or modifications not expressly approved by ADTRAN could void the user’s
authority to operate the equipment.
To prevent electrical shock, do not install equipment in a wet location or during a lightning
storm.