User Manual
Table Of Contents
- Trademarks
- About this Manual
- Federal Communications Commission Radio Frequency Interference Statement
- Warranty and Customer Service
- Customer Service, Product Support Information, and Training
- 4205 System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- Troubleshooting Guide
Section 5, User Interface Guide TRACER 4205 System Manual
44 © 2002 ADTRAN, Inc. 612804205L1-1A
>TRACER SYSTEM CONFIGURATION > SITE NAME
Enter up to 32 alphanumeric characters to be displayed for identification of the TRACER 4205 system.
>TRACER SYSTEM CONFIGURATION > MODEM CONTROL
Configures the modem control leads on the RS-232 port (terminal interface located on the rear panel of the
unit). Set MODEM CONTROL to ENABLED when connecting the unit to a modem (using a null modem
adapter). Setting
MODEM CONTROL to DISABLED prevents the TRACER 4205 from monitoring DCD and
enables data to be sent to the VT 100 continuously.
MODEM CONTROL must be set to DISABLED when the
VT100 terminal is in use. The TRACER 4205 comes factory programmed with MODEM CONTROL set to
DISABLED.
>TRACER SYSTEM CONFIGURATION > MODEM CONNECTION (LOGOUT)
Activator to cause the TRACER 4205 to de-assert Clear To Send (CTS) and DSR for a time greater than 20
milliseconds. This signals the modem to disconnect the analog connection. Hangup-On-DTR-Drop may
need to be explicitly enabled on some modems. If PASSWORD PROTECTION is ENABLED, this menu also
causes the unit to close the current session and return to the TRACER System Status menu page and wait
for password input.
>TRACER SYSTEM CONFIGURATION > PASSWORD ENABLE
Configures password protection for the VT100 terminal interface. Password protection for the TRACER
4205 requires password input from the TRACER System Status menu page when connecting to the unit.
When configured for Password protection, the TRACER 4205 closes any terminal session that remains
inactive for more than 10 minutes. The TRACER 4205 comes factory programmed with
PASSWORD
E
NABLE set to DISABLED.
>TRACER SYSTEM CONFIGURATION > PASSWORD
Sets the password for password protection of the TRACER 4205 VT100 terminal interface. Enter up to 8
alphanumeric characters. The system password is case sensitive.
>TRACER SYSTEM CONFIGURATION > PERFORMANCE STATS (CLEAR)
Activator to reset all system error counters for the TRACER 4205.
Press <Ctrl+Z> three times from the terminal interface to temporarily disable MODEM
C
ONTROL when the modem control leads are active.
The default password for the TRACER 4205 is tracer.