User's Manual
3
• To connect to an international
power supply, use an attachment
plug appropriate for the power
outlet, as outlined in the "Technical
Specications" section of this
manual.
• Unplug the device if it is not to
be used for an extended period
of time. To disconnect the cord,
unscrew the plug rst, then pull
the cord out by the plug. Never
pull the cord itself.
• Do not expose the device to
moisture or apply liquid cleaners
directly to the screen. Spray the
cleaning solution into a so cloth
and clean gently. For further detail,
refer to the "Periodic Maintenance"
section of this manual.
• Allow adequate air circulation to
prevent internal heat buildup. Do
not place the device on surfaces
(rugs, blankets, etc.) or near
materials (curtains, draperies) that
may block the ventilation slots.
e device is cooled by natural
convection and has no fan.
• Do not touch the patient with
signal input or output connectors.
Equipment with SIP/SOP
connectors should either comply
with IEC60601-1 and/or IEC
60601-1-1 harmonized national
standards or the combination
should be evaluated for safety.
• To ensure electromagnetic
compatibility, refer to the
“Electromagnetic Compatibility”
section of this manual. e WiSe
19" HDTV Surgical Display
(0240030990) must be installed
and operated according to the
EMC information provided in this
manual.
• Pay close attention to the cleaning
instructions in this manual. A
deviation may cause damage.
• Do not install the device
near sunlight, excessive dust,
mechanical vibration, or shock.
• Do not operate with the glass
device screen facing downward.
• Handle the device with care. Do
not strike or scratch the screen.
• Changes or modications not
expressly approved by the party
responsible for compliance could
void the user’s authority to operate
the device.
Note: is device has been tested and
found to comply with the limit for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. ese limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. is device generates, uses,
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
ere is no guarantee that interference will
not occur in a particular installation, which
can be determined by turning the device
o and on. e user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving device.
• Increase the separation distance between
the device.
• Connect the device to an outlet on a
circuit dierent from that to which the
other device(s) are connected.
• Consult the manufacturer or eld service
technician for help.