User's Manual

Cautions

1. Connect the device to an AC adapter connected to a hospital grade power cord ensuring the power cord is plugged

into a grounded power outlet to achieve grounding reliability.

2. Do not sterilize the device, as the delicate electronics cannot withstand this procedure.

3. Use only the proprietary surgical display power supply for the display. Completely secure the connection between the

DC power cord and the extension cord.

4. Never operate the device immediately after transportation from a cold location to a warm location.

5. To connect to an international power supply, use an attachment plug appropriate for the power outlet

6. Unplug the device if it is not to be used for an extended period of time. To disconnect the cord, unscrew the plug first,

then pull the cord out by the plug. Never pull the cord itself.

7. Do not expose the device to moisture or apply liquid cleaners directly to the screen. Spray the cleaning solution onto a

soft cloth and clean gently. For further detail, refer to the "Cleaning and Maintenance" section of this manual.

8. Allow adequate air circulation to prevent internal heat buildup. Do not place the device on surfaces (rugs, blankets,

etc.) or near materials (curtains, draperies) that may block the ventilation slots. The device is cooled by natural

convection and has no fan.

9. Do not touch the patient with signal input or output connectors. Equipment with SIP/SOP connectors should either

comply with IEC 60601-1 and/or IEC 60601-1-1 harmonized national standards or the combination should be evaluated

for safety.

10. To ensure electromagnetic compatibility, refer to the “Electromagnetic Compatibility” section of this manual. The 32”

4K Surgical Display (240-031-050) must be installed and operated according to the EMC information provided in this

manual.

11. Pay close attention to the cleaning instructions in this manual. A deviation may cause damage.

12. Do not install the device near sunlight, excessive dust, mechanical vibration, or shock.

13. Do not position the device so that it is difficult to disconnect the power cord from the supply mains.

14. Do not operate with the glass device screen facing downward.

15. Handle the device with care. Do not strike or scratch the screen.

16. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate the device.

17. Note: This device has been tested and found to comply with the limit for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications. There is no

guarantee that interference will not occur in a particular installation, which can be determined by turning the device

off and on. The user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving device.

• Increase the separation distance between the device.