Service manual

FORM NO. 56043098 - Convertamatic
™
24C, 24D, 26C, 26D, 28C, 28D - 19
SOLUTION SYSTEM
SOLUTION FILTER AND BALL VALVE REMOVAL
1 Drain the solution tank using the solution drain hose (B).
2 See Figure 4. Loosen the (2) Hose Clamps (K) and pry off the inlet Solution Hose (L) and Solution Hose (M).
3 Remove the Nut (N) that secures the Filter Mount Bracket (O) to the chassis and remove the assembly from the machine.
FIGURE 4
SOLUTION PUMP REMOVAL
1 Drain the solution tank or turn the solution fi lter ball valve to the off position to prevent solution loss.
2 See Figure 4. Loosen the (2) Hose Clamps (P) and pry off inlet Hose (M) and outlet Hose (Q) from Solution Pump (R).
3 Remove the (2) 10-24 nuts (S) that secure the Solution Pump to the Chassis.
4 Disconnect the Solution Pump Electrical Connector (T); (A tie strap may need to be cut) completing the part removal.
NOTE: Refer to the APPENDIX at the back of this manual for solution system fl ow schematics and detergent system information.