Instruction Manual

ManualsBrandsAdvance Adapters ManualsCar50-4200

ADVANCE ADAPTERS, INC P/N: 50-4200

P.O. Box 247, 4320 Aerotech Center Way Old Part No:711042

Paso Robles, CA 93447 PAGE 1 OF 2

Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 09-27-10

SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will

void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend

that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a

service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive

dealerships and parts stores.

KIT CONSISTS OF:

No. Qty Part No. Description

1. 1 51-2500 CASTING (Ref: 711125)

2. 1 52-2500 SHAFT (Ref: 711325)

3. 1 716061 VENT

4. 1 716223 RETAINER

5. 1 716513 GASKET

6. 1 716713 SEAL (C-R #18676)

7. 1 716714 O-RING

8. 1 716455 SNAP RING

FORD C4 AUTOMATIC - BRONCO

DANA 20 (1966-76)

Summary of content (2 pages)

PAGE 1
ADVANCE ADAPTERS, INC P/N: 50-4200 P.O. Box 247, 4320 Aerotech Center Way Paso Robles, CA 93447 Telephone: (800) 350-2223 Fax: (805) 238-4201 Old Part No: 711042 PAGE 1 OF 2 Page Rev. Date: 09-27-10 FORD C4 AUTOMATIC - BRONCO DANA 20 (1966-76) KIT CONSISTS OF: No. Qty Part No. Description 1. 2. 3. 4. 5. 6. 7. 8.
PAGE 2
ADVANCE ADAPTERS INC. P/N: 50-4200 P.O. Box 247, 4320 Aerotech Center Way Paso Robles, CA 93447 Telephone: (800) 350-2223 Fax: (805) 238-4201 Old Part No: 711042 PAGE 2 OF 2 Page Rev. Date: 11-07-97 FORD C4 AUTOMATIC - BRONCO DANA 20 (1966-76) INSTALLATION INSTRUCTIONS: This kit is designed to install a Ford C4 automatic to an early Bronco transfer case. To install the new main shaft supplied with this kit, the C4 must be disassembled.