Manual

ADVANCE ADAPTERS INC. P/N: 712500T
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447 PAGE 1 OF 1
Telephone: [phone] Fax: [phone] Page Rev. Date: 10-18-12
KIT CONSISTS OF:
No. Qty Part No. Description
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are
normally available at automotive dealerships and parts stores.
OPTIONAL ITEMS:
1. 1 711500M McLEOD 168 FLYWHEEL
2. 6 716141A 11mm FLYWHEEL BOLTS
3. 1 LC165473S CLUTCH ASSY. 11"
4. 1 716314 T/O BEARING
5. 1 716155 PILOT BUSHING SPACER
6. 1 716175 T/O BEARING COLLAR
7. 5 720028 10mm X 1.5 BELLHOUSING BOLTS
8. 5 720038 10mm LOCKWASHER (for bhsg. bolts)
9. 6 723761 XRP DOWEL BOLTS (pressure plate)
10. REMOVE THE T/O BEARING OUT OF P/N LC165473S
LS SERIES GEN. III MANUAL TRANS.
CONVERSION KIT (.400" RECESSED CRANK)
GENERAL INFORMATION:
Since the LS series flywheels only fit a LS series block and the engine crank is recessed .400”, there are a couple of
things that must be addressed. Usually our bellhousing kits include a new pilot bushing. A problem occurs because the
1.090” diameter that our bushings fit into on a standard GM is now .400” closer to the back of the block, creating a pilot
bushing engagement problem. This kit comes with a pilot bushing spacer for the manual transmission applications. The
spacer in this kit sets the pilot bushing in the correct location. NOTE: The grove on this bushing must be facing out when
installed into the engine crank.
The second issue is the flywheel. The flywheel in this kit only fits the recessed crank and bolts to the crank without a
flywheel spacer. There are some LS series blocks that do not have the recessed crank. This kit will not work on these
blocks. One block that we know of is the 6.0L with cast iron heads and the 4.8 engine coupled only to a stock manual
transmission in 1999 to 2003
. A custom flywheel would have to be made to work on these block.
The pressure plate and clutch disc are also included in this kit. These components are specifically designed for the LS
series engine. The bolts have also been included to allow proper alignment of the pressure plate to the flywheel.
The release bearing in this kit is a custom bearing. When coupled to a stock transmission, the LS series engine used a
internal release bearing. Our full bellhousings are not compatible with the stock internal setup. This bearing design is
manufactured to replace the internal bearing with a conventional bearing setup. Do not use any other type of release
bearing with this conversion. Premature clutch failure could occur.
On Toyotas using a Marks 4WD Adaptor kit, the throw out bearing collar is not used.
P/N 716286 is a bracket that fits
our NV4500 full bellhousings.
P/N 716213 slave cylinder fits this
bracket.
P/N 717514 Stock manifold collec-
tor rings and gasket kit.