Manual

ManualsBrandsAdvance Adapters ManualsCarKJ09138BK

TOOLS NEEDED

• Metric tools

• Floor jack

• Jack stand (s) 4

• Wheel chocks

BILL OF MATERIALS

Part # Description Qty

M03759

3/4 FT spacers 2

M03762

3/4 Rear spacers 2

M03758

1 3/4 FT Spacers 2

M03761

1 3/4 Rear spacers 2

S11090

Drop brackets 2

S10373

Bolts 4

S11051

Washers 4

P11183

Loctite 1

Other Jeep JK Products

• KU09059 EVS Foam bump-stops

• KU09060 EVS Foam bump-stops

• KU70034 Ft lower control arms

• KU70033 Rear upper control arms

• KU70037 Rear lower control arms

• KU70091 poly flex tool

• KU11005 Poly lube gun

• KJ71020 Upper dash panel

• KJ71030 Lower switch panel

• KU01005 FT Shock

• KU01008 Rear shocks

BOM FOR 3/4 KIT

BOM FOR 1 3/4 KIT

KJ09138 / KJ09137

2007 to Current Jeep JK 3/4 & 1 3/4 lift kits

www.Daystarweb.com

Tech Support Contact Info

Tech@DaystarWeb.com

Phone: 623.907.0081

Fax: 623.907.0088

841 South 71

Avenue

Instruction Sheet P11162

2007 Daystar Products International Inc.

Hells gate, Moab UT

Summary of content (4 pages)

PAGE 1
TOOLS NEEDED • • • • Metric tools Floor jack Jack stand (s) 4 Wheel chocks BILL OF MATERIALS BOM FOR 3/4 KIT Part # Description Qty M03759 3/4 FT spacers 2 M03762 3/4 Rear spacers 2 Other Jeep JK Products • • • • • • • • • • • KU09059 EVS Foam bump-stops KU09060 EVS Foam bump-stops KU70034 Ft lower control arms KU70033 Rear upper control arms KU70037 Rear lower control arms KU70091 poly flex tool KU11005 Poly lube gun KJ71020 Upper dash panel KJ71030 Lower switch panel KU01005 FT Shock KU01008 R
PAGE 2
Thank you for choosing Daystar Products Daystar recommends a certified technician install this system . In addition to these instructions, professional knowledge of disassemble/reassembly procedures as well as post instructions checks must be known. Attempts to install this system without this knowledge and expertise may jeopardize the integrity and/or operating of the vehicle. 11. With the coil removed , install the rear lift spacer over the stock spring isolator and install the coil springs.
PAGE 3
Installation steps Install the front wheels and lower off the jack stands Place the wheel chock at the front wheels and jack up the rear suspension and support the vehicle at the frame and remove the rear tires. 9. With the jack under the rear axle, jack up it up so you can disconnect the rear shocks and rear sway bar at the frame and the bracket that holds the brake line to the frame. 7. 8. 10. Lower the axle down to remove the coil springs. 1.
PAGE 4
3. Disconnect the ABS line form the bracket on the steering knuckle on the driver side then the passenger side. 4. With the shocks , sway bar end link and ABS line disconnected lower the axle down to remove the coil springs on the driver side first then the passenger side. 5. With the coil spring removed install our lift spacer over the stock spring isolator. 6.