User's Manual

C. Installation Steps for 3G Connection

Step 1. Plug in power:

Connect with the power adapter to the receptor on the

back panel of it. Then the device will be powered on.

Step 2. Set WAN mode switch:

Set WAN mode switch at “3G” side.

Step 3. Connect with a USB 3G modem:

Plug your USB modem which is with activated SIM

card provided by your 3G service provider.

Step 4. Connect with Ethernet Cable

Insert the Ethernet cable into RJ45 Ethernet Port on

the back panel. And then plug the other end of RJ45

into the computer or Laptop computer.

Step 5. Start to configure the device:

You can start to configure the device via the Easy

Setup Utility.

(see Easy Setup Utility in CD)

Note. If you set WAN mode switch at “DSL” side, the Ethernet port will became WAN port for you

connect to xDSL modem. Your PC or laptop can only connect to it via WLAN at this condition.