User's Manual Part 1

Chapter 錯誤! 尚未定義樣式。 - 錯誤! 尚未定義樣式。
錯誤! 尚未定義樣式。
3-24
 Network ID (SSID): Network ID is used for identifying the Wireless
LAN (WLAN). Client stations can roam freely over this product and
other Access Points that have the same Network ID. (The factory
setting is "default".)
 Channel: The radio channel number. The permissible channels
depend on the Regulatory Domain.
 Security: Select the data privacy algorithm you want to protect your
data when being transferred from one station to another. The
available security protocols are:
¾ None – No encryption is applied. (default)
¾ WEP (Wired Equivalent Privacy) – Encrypts frames
transmitted through a wireless module using a pre-entered
WEP key. You can configure 4 key sets and select one to
apply as follows:
 WEP 64 bit - 10 hexadecimal digits
 WEP 126 bit – 26 hexadecimal digits
 WEP 258 bit – 58 hexadecimal digits
¾ 802.1x – When enabled, the wireless user must be
authenticated before it is allowed to use the network services.
One implementation of 802.1x (the most common one) is
through a RADIUS server on your LAN, containing an
authentication database.
 Encryption Key Length – Select either 64 or 128 bits for
the encryption key.
 RADIUS Server IP – The 802.1x server's IP address.
 RADIUS Port – The 802.1x server's service port.
 RADIUS Shared Key – Key value shared by the RADIUS
server and the networking gateway. The key value is
consistent with the one in the RADIUS server.
¾ WPA-PSK – Accepts WPA clients only. Manually enter a pre-
share key (encryption key) as follows:
 Pre-share key mode: ASCII or HEX can be selected.
 Pre share key: 32 ASCII characters or 64 hexadecimal
digits pre-share key (encryption key).
刪除: 3
刪除: 3
刪除: Operation and
Administration
刪除: Operation and
Administration