User's Manual Part 2

錯誤! 尚未定義樣式。
Wireless Networking Gateway System Manual
3-49
 Password/Key – Enter your password or key according to the DDNS
provider you selected.
After Dynamic DNS setting is configured, click Save.
SNMP Setting
The Simple Network Management Protocol (SNMP) provides the user
with the capability to remotely manage a computer network by polling
and setting terminal values and monitoring network events.
Figure 45: SNMP Setting
 Enable SNMP - You must check either Local or Remote or both to
enable SNMP function.
¾ Local - The device will respond to requests from LAN.
¾ Remote – The device will respond to requests from WAN.
 Get Community – Set the password for GetRequest access rights to
your device.
 Set Community - Setting the password for SetRequest access rights
to your device.
 IP 1,IP 2,IP 3,IP 4 - Enter your SNMP addresses for allowed
managers. The user has to configure to where this device should
send SNMP Trap messages.
 SNMP Version - Select the proper SNMP Version supported by your
SNMP Management software.
In the above figure:
刪除: Set TCP/IP Protocol
for Working with NAT
Router
刪除: Wizard