User's Manual Part 2

Chapter 錯誤! 尚未定義樣式。 - 錯誤! 尚未定義樣式。
錯誤! 尚未定義樣式。
3-50
 The device will respond to requests from both LAN and WAN.
 The device will respond to SNMP clients whose get community is
set as "public".
 The device will respond to SNMP clients whose set community is
set as "private".
 This device will send SNMP Trap messages to 192.168.123.33
(Using SNMP Version V2c).
Routing Table
Routing allows you to determine which physical interface address to use
for outgoing IP data grams. If you have more than one gateway and
subnet, you will need to enable Routing Table to allow packets to find
the proper routing path and allow different subnets to communicate
with each other.
Figure 46: Routing Table
Routing Table settings are settings used to setup the functions of static
and dynamic routing.
 Dynamic Routing - Routing Information Protocol (RIP) will exchange
information on destinations for computing routes throughout the
network. Select RIPv2 only if you have a different subnet on your
network. Otherwise, select RIPv1 if you need this protocol.
刪除: 3
刪除: 3
刪除: Operation and
Administration
刪除: Operation and
Administration