User's Manual

Step 3: Open the DOS command from the Start Menu->Run. Type “cmd” in
the Open folder, then click OK to enter the DOS environment.
Step 4: type the “ipconfig” and press the “Enter” in the DOS environment.
Then the following message should be found.
Check the IP address, Subnet Mask, and Default Gateway address are
same as previous settings. If same, you are successful to set up the network
configuration.
WARNING:
We strongly recommended that you enable wireless encryption feature
or add ACL rules on MGB100. Otherwise, everyone can connect to it
wirelessly and access data in your hard drive.
23