User's Manual

- 11 -
1. Profile Name: Different AP can be set up into different Profile Name
2. SSID: The drop-down menu can select which AP is detected by system
3. Power Save Mode: can select〔CAM（Constantly Awake Mode）〕 or 〔Power Saving Mode〕
mode. Selecting the” CAM when AC Power” means the power saving mode can automatically
switch into CAM, if the computer uses the AC power, not using the batteries instead. Selecting
the “Power Save Mode” can only work under the infrastructure mode.
4. Network Type: Can select “Infrastructure” or “802.11 Ad Hoc” mode. When set up to
“Infrastructure” mode, the “Power Saving” mode will be enabled, but the “11b Preamble Type”
will not; When set up to “802.11 Ad Hoc” mode, the “Power Saving Mode” will not be enabled,
but “11b Preamble” will, and the channel selection in the session 7 will show up as well.
5. TX Power: Transmit power, the amount of power used by a radio transceiver to send the signal
out. User can choose power value by sliding the bar.
6. Preamble: There are three types, Auto, Long and Short are supported.
7. Ad hoc wireless mode: There are five types. 802.11B only, 802.11 B/G mixed 802.11A only,
802.11 A/B/G mixed and 802.11G only modes are supported.