User's Manual

D. CHIRP INDICATORS :

Chirp Function

1 chirp Arm

2 chirps Disarm

3 chirps Defective reminder

4 chirps Disarm / Triggered

6 chirps Car locator

E. PARKING LIGHT :

Parking light Function

1 flash Arm

2 flashes Disarm

3 flashes Disarm / Triggered

5 flashes Transmitter low battery.

(suitable for random code only)

12 flashes Car locator

F. OVERRIDE/VALET SWITCH :

1. OVERRIDE FUNCTION: (System in arm condition)

Use in emergency, like lost or malfunctions of transmitter. Turn ignition on, within 10 seconds push the

override/valet switch, the siren will stop and the system disarmed.

2. VALET MODE: (System in disarm condition)

Vehicle in for maintenance or valet parking, the system will not arm.

a. Turn ignition on then within 10 seconds push and hold override/valet switch for 2 seconds, the LED will

turns on indicates the system is in 'valet mode'.

b. System stay in 'valet mode', transmitter still can remote operating lock or unlock the doors, parking

light, pop trunk release and panic function. But no alarm function.

c. Return to normal operation, turn ignition 'on', then within 10 seconds, push and hold override/valet

switch for 2 seconds, it will exit the valet.

G. PASSIVE ARMING :

It operate as below:

1. Turn 'off' the ignition.

2. Leave vehicle and close all doors.

3. LED fast flashing.

4 After 30 sec. System auto arming

Note: during the 30 sec. If open the door the time will stop counting down, until all doors closed then again

re-start count down for 30 sec.

Passive arming by-pass: Press button 2 twice (designated channel setting), to temporally by-pass

passive arming. That's for prevent locking yourself out of the vehicle (For example fill up the gas).

A short chirp will confirm this by-pass.

Re-open the door will not start the passive arming again.

Note: It’s only temporally by-pass. When turn ignition ‘on - off ‘ or use transmitter to arm or disarm, this by-

pass will cancel.

H. ACTIVE ARMING :

1. Press arm button on transmitter.

2. The siren will chirp once after 3 seconds the system will be fully arm.

NOTE: Defective sensor reminder: 3 chirp indicate defective sensor occurred.

Special Note: If the system is interfacing with optional sensor, such as PIR or door/window sensor, upon

system armed, if the PIR or door sensor triggered, the system will full alarming.