User's Manual

Here’s how “Noise Abatement Circuit” works: The alarm triggers five times or ten times for warn-away
triggers. Each time, the same sensor (zone 4 or zone 6) is triggering the alarm. “Noise Abatement Circuit”
will interpret this pattern of triggers as false alarm. After the fifth trigger (tenth for warn-away), “Noise
Abatement Circuit” ignores, or bypasses that sensor until the other sensor or switch is trigger.
“Noise Abatement Circuit” covers doors (Hood/Trunk) differently: If the alarm is triggered by an open door
for six full cycles, the doors will be bypassed until the trigger ceases.
M. ANTI CAR- JACKING
Warning: If you don't need the car jacking function in this alarm system, be sure to set car jacking feature
“OFF”. This system is default setting all car-jacking “OFF”.
ACTIVE ANTI CAR JACKING:
1. Spin up the
switch to the page 1 and then press and hold the “Car Jacking”
button for 2 seconds or press and hold the transmitter
and buttons at the
same time for 5 seconds while the vehicle’s ignition is ON. The parking lights will
turns on for 1.5 seconds to indicate the system enters the car-jacking mode.
2. Once the system in car-jacking mode, If you are forced from the vehicle, the
system will be trigger when the door is opened and closed while the ignition is
“ON”.
PASSIVE ANTI CAR- JACKING:
1. Turn the ignition switch to “ON” position; the system enters the car-jacking mode.
2. Once the system in car-jacking mode, If you are forced from the vehicle, the
system will trigger when the door is opened and closed while the ignition is “ON”.
TRIGGER THE ANTI CAR -JACKING MODE:
a). 50 seconds after the system has been triggered. The siren will start chirping for 15 seconds.
b). During this 15 seconds period of chirping, you will be alerting to push the valet switch once to turn off
the car-jacking feature. If not, it will enter second timer car jacking.
c). 65 seconds after the system has been triggered. The siren starts alarming and the parking light starts
flashing.
d). 90 seconds after the system has been triggered
1. The siren still alarming and the parking light flashing, and
2. The starter disable will activate to prevent the vehicle from starting.
3. It will remain active until the vehicle's battery power exhausted.
OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren will stop and
the system disarmed
Note: If you use password pin code to double protect the vehicle security, you will need to use it to
completely disarm the system.
N. SYSTEM’S TRIGGER CHECK
Spin up the
switch to the page 4 and then press the “Trigger
Check” button, it responds with one melody sound and all trigger’s
records will immediately displayed on the OLED screen.
Note: If it has no responds then you are out of range.
O. SYSTEM’S STATUS CHECK
Spin up the
switch to the page 4 and then press the “Status
Check” button, it responds with one melody sound and all vehicles’
status records will immediately displayed on the OLED screen.
Note: If it has no responds then you are out of range.
P. DRIVER PAGING / LOSE & FOUND
It is useful the event that someone wants to page the driver of the parked vehicle or someone cannot find
his OLED remote transceiver.
Indoor Driving Paging
Under the ignition switch “off” condition, press and hold the valet switch for 2 seconds
to page the driver, one chirp sound shall be emitted from the vehicle and the paging
melody sound continues sounding from you Remote OLED transceiver and “DRIVER
PAGING” indication flashes on the OLED screen.
16