User's Manual

Q. DOME LIGHT CONVENIENCE DELAY & SUPERVISION
The alarm with a unique feature which will turn on your vehicle dome light as following:
1. Upon disarming, the interior light will remain on for 30 seconds.
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turn on the ignition switch or arm the alarm will turn off the dome light.
R. IGNITION CONTROL DOOR LOCK/UNLOCK. (See Alarm Feature II – 2 Programming).
If the vehicles door locks have been interfaced to the security system, the system will automatically lock
the vehicle's doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is
turned “OFF”.
S. TRUNK RELEASE (CHANNEL 3) OUTPUT.
Press and hold
button on the transmitter for two seconds to remote control the
trunk release or other electric devices.
T. AUXILIARY 1 /2/3/4 TIMER CONTROL OUTPUT
Activate The AUXILIARY 1: Spin up the
switch to the page 3 and then press the “Auxiliary 1” button or
press the transmitter
and buttons at the same time to active Auxiliary 1 function.
Activate The AUXILIARY 2: Spin up the switch to the page 3 and then press the “Auxiliary 2” button or
press the transmitter
and buttons at the same time to active Auxiliary 2 function.
Activate The AUXILIARY 3: Spin up the switch to the page 3 and then press the “Auxiliary 3” button or
press the transmitter
and buttons at the same time to active Auxiliary 3 function.
Activate The AUXILIARY 4: Spin up the switch to the page 3 and then press the “Auxiliary 4” button or
press the transmitter
and buttons at the same time to active Auxiliary 4 function.
The channel output is user-programmable timer output. For instance, this timer output may be used to turn
on the headlight, power window or sunroof. (Factory defaults setting at momentary output.)
U. MULTI- VEHICLE SECURITY OPREATION:
Your remote transmitter can be utilized to control multi- vehicle security system, to program the remote
control transmitter to a second vehicle, follow the instructions for Transmitter programming. All
programming parameters be the same except for the following:
For Regular Remote Control Transmitter:
1. Prior to pushing any button on the transmitter. Press the Select
II button first on the transmitter.
2. Once
II button is pressed the LED on the transmitter will illuminate for 3.5 seconds to indicate the
second transmitter pin code has built-in.
3. While the LED is illuminated, press any button on the remote control transmitter to control a second
vehicle security system.
For 2-way OLED Remote Control Transceiver:
A maximum of
four vehicle’s
security system
can be control
by this
transceiver.
TX1 White Vehicle
TX2 Blue Vehicle
TX3 Yellow Vehicle
TX4 Green Vehicle
The four transmitters will
display on the OLED
screen, you can choice
one of four transmitters
to control your vehicle
security system.
Now you can press
button to remote control
The “TX 3” yellow
vehicle security system.
17