User's Manual

ManualsBrandsAdvance Security ManualsToys & GamesRemote Control Car Alarm Transceiver

APR/30/2003

RST771A OP

[4] Chirps form siren/horn, [3] flash from parking light to indicate the system was disarmed.

Note 1: You must override the alarm within 60 seconds. If not, the system will automatically re-arm.

EXAMPLE: To Override The System With The Password Code 83, you would;

1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm will sound.)

2. Within 5 seconds, Press and Release the Valet Switch 8 times

(When finished above procedures, system's siren stops alarming, parking light stop flashing, other

sensor stop trigger, but the vehicle can not be start and drive away.)

3. Within 15 seconds of the last digit code enter (the 1

code), turn the Ignition Switch “Off” and then “ON”.

4. Within 15 seconds, Press and Release the Valet Switch 3 times

5. Turn the Ignition Switch to “Off” position.

[4] Chirps form siren/horn, [3] flash from parking light to indicate the system was disarmed.

K. VALET MODE: (System in Disarm or Valet mode)

The valet switch allows you to temporarily bypass all alarm function, eliminating the need to hand your

transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm

function and remote start function are bypassed, however the remote panic feature and remote door

locks will remain operational. To use the valet mode, the system must first be disarmed either by using

you remote transmitter, or by operating the Manual override sequence.

Enter Valet Mode:

1. From the disarmed condition, turn the ignition to

“ON” position.

2. Push and hold valet switch for 2 seconds until

the LED turns on. The LED wills remain on as

long as the system is in 'valet mode'.

Remote Door Lock

Remote Door Unlock

Exit Valet Mode:

1. Return to normal operation, turn ignition 'on'.

2. Push and hold valet switch for 2 seconds, The LED wills turns off indicate the system are exiting the

valet mode.

L. CAR LOCATOR

Under armed mode, press the

button to active car locator function. The siren will

chirp 6 times. The parking light will flash 12 times, for you to easily locate your car.

M. PANIC FUNCTION: (See Alarm Feature I - 7 Programming.)

The transmitter can be used as a remote panic switch to manually trigger the alarm in case emergency.

1. Press and hold the

button for 3 second. The alarm will immediately sound.

2. During panic mode, the normal function of this transmitter button will be suspended.

The transmitter

and buttons can be used to lock and unlock the door (if the

option is installed), however once the

button is pressed, the vehicle’s starter

disable device, (where installed) will be enable allowing the vehicle to start.

3. To stop the alarm, press and hold the transmitter

or button on the transmitter again for 3

seconds. Also if any transmitter button other than

or button is pressed and released, the panic

mode will be turned off immediately.

4. If the button is not pressed, the alarm will automatically stop after 60 seconds.

N. TRIGGER THE SYSTEM

When armed, your vehicle is protected as follows:

1. Light impact will trigger the warn-away signal.

2. Heavy impacts / Doors open / Hood open / Trunk open / Turn on the ignition key will trigger the

programmed sequence.

The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren, horn, parking

lights, and dome light will turn on to alerting of an intrusion for 60 seconds. Then it will stop and automatic

reset and re-arm. If the one of sensors or detectors still active, the alarm system will sound a maximum of

3 times of 60 seconds cycles.