Installation Instructions for FC, FE, and FS Sinks

CHECK FOR CONCEALED DAMAGE

FILE CLAIM WITH DELIVERING FREIGHT CARRIER

Sinks manufactured by ADVANCE TABCO

are designed and constructed for the use of

liquid containment. Suggested applications include Food Preparation, Manufacturing, Cooking,

Laboratory and Service and the like. ADVANCE TABCO

does not recommend product use for activities

employing harsh and active chemicals. Please consult factory regarding unusual applications.

Installation Instructions for

FC, FE & FS SERIES SINKS

FE Series

FC Series

FS Series

PAGE 1
Installation Instructions for FC, FE & FS SERIES SINKS FS Series FE Series FC Series CHECK FOR CONCEALED DAMAGE FILE CLAIM WITH DELIVERING FREIGHT CARRIER Sinks manufactured by ADVANCE TABCO® are designed and constructed for the use of liquid containment. Suggested applications include Food Preparation, Manufacturing, Cooking, Laboratory and Service and the like. ADVANCE TABCO® does not recommend product use for activities employing harsh and active chemicals.
PAGE 2
THIS CARTON CONTAINS: • Sink Unit • Leg Assembly • Drains (1 For Each Sink Bowl) TOOLS NEEDED (Not Included): 5/32” Allen Wrench Step 1 Carefully remove contents of carton/crate. Carefully position sink upside down on a protected surface so you can access the underside of the sink. Install leg assembly into gussets at each end (Figure 1). Figure 1 Step 2 Tighten each Set Screw using 5/32” Allen Wrench (Figure 2).
PAGE 3
Step 3 Carefully turn sink over onto its legs. Check for stability and adjust Bullet Feet as necessary (Figure 3). Figure 3 Drain Installation Details Step 4 Install drain(s) & faucet. Your knowledgeable plumbing contractor is responsible for local code requirements. You can also visit our website at advancetabco.com/support for drain & faucet details. K-6 Basket Drain shown 1/4” continuous bead of Plumber’s Putty or Silicone Sealer.
PAGE 4
NOTE: NSF installations require sink unit to be installed to wall or at least 1” of the wall (Figure 5).