Installation Instructions for FC, FE, and FS Sinks

Step 1
Carefully remove contents of carton/crate. Carefully position
sink upside down on a protected surface so you can access the
underside of the sink. Install leg assembly into gussets at each
end (Figure 1).
Step 2
Tighten each Set Screw using 5/32” Allen Wrench (Figure 2).
THIS CARTON CONTAINS:
• Sink Unit
• Leg Assembly
• Drains (1 For Each Sink Bowl)
TOOLS NEEDED (Not Included):
5/32” Allen Wrench
PLEASE NOTE: Some models may require Set
Screws to be inserted into the Set Screw Holes.
Figure 1
Figure 2
☞