Installation Instructions for Keg Racks

STEP 4: INSTALLING OPTIONAL KR-1 REAR KEG STRAP
(If a Rear Keg Strap is not being used, proceed go to STEP 5)
Quantity Parts Description
(1) Top Shelf (Note: Top Shelf has 4 horizontal bars)
(2) Lower Shelves
(4) Posts
(24) 5/16-24" x 3/8" Set Screws
TOOLS REQUIRED: 7/32" Allen Wrench
Rubber Mallet
Tape Measure
Figure 1
Figure 3
Figure 2
KEG RACK CONTENTS INCLUDE:
STEP 1:
Pre-install all Set Screws using a
7/32" Allen Wrench
(Figure 1).
STEP 2:
Using a tape measure, mark desired shelf heights on all Posts. (Figure 2).
STEP 3:
Slide Tubular Posts into one Lower Shelf (to desired height) and tighten
Set Screws.
(Figure 3). Slide second Lower Shelf onto posts (to desired height)
& tighten Set Screws.
Install optional Rear Keg Strap at desired height between lower shelves and
tighten Set Screws
(Figure 4).
Figure 4
Continued >>