Installation Instructions for Work Table

TABLES with Undershelf
TABLES with Open Style Tubular Base
This package contains Table Top, Undershelf, Legs & Set Screws
Tool required for installation:
5/32 Allen wrench.
Step 1:
Lay the table top flat on the box to
protect the finish during assembly.
(Figure 1)
Figure 1
Figure 1
Step 4:
Insert legs and undershelf assembly into
gussets as indicated in (Figure 4).
Tighten set screws.
This package contains Table Top, Front to Back Leg Assemblies,
Rear Leg Assembly & Fasteners
Step 2:
Remove plastic cap from gusset. (Figure 2).
Set screws are located inside gusset.
NSF Installations require all set screws filled
with an approved silicone sealer.
NSF Installations require all set screws filled
with an approved silicone sealer.
Figure 4
Step 4:
Insert leg assembly into gussets as
indicated. (Figure 4)
Tighten all set screws.
Step 2:
Remove plastic cap from gusset (Figure 2).
Set screws are located inside gusset.
Step 3:
Insert top of leg into adjustable shelf corner
(bottom of undershelf). Align score line with top
of undershelf (Figure 3). Insert Allen Head Set
Screws into adjustable shelf corner and tighten
(Figure 3A).
Figure 2
Figure 2
Figure 3A
Figure 4
Figure 3
Figure 3
Figure 3A
Tool required for installation:
5/32 and 7/32 Allen Wrench.
Step 1:
Lay the table top flat on the box to
protect the finish during assembly.
(Figure 1)
Step 3:
Align rear cross brace with hole at rear of “H” leg
assembly & fasten using 3/8”-16 x 2-1/2” stain-
less steel button head socket bolt and tighten
(Figure 3). Seal hex head with NSF approved
silicone sealant (Figure 3A).
Score Line