Installation Instructions for SHD Series Drawers

Contents:

(1) Outer Drawer Chassis

(1) Inner Drawer Chassis

(1) Stainless Steel Drawer Pan

(4) 1/4-20 x 1/2” Bolts with Nuts

Tools Required:

(2) 7/16” Open end Wrenches

Step 1:

Fully extend Inner Drawer

Chassis and remove stainless

steel Drawer Pan (Figure 1).

Step 2: Remove Inner

Drawer Chasis by lifting up

on drawer front handle to

clear “Safety Stop”

(Figure 2).

Step 3:

Install Outer Chassis to Work Table Drawer Angles under side of table top

(Figure 3). Use 1/4-20 x 1/2” bolts and nuts provided to secure.

NOTE: Outer Drawer Chassis mounts to the INSIDE of each Drawer Angle.

Figure 1

Figure 2

Figure 3