Installation Instructions for SHD Series Drawers

3
Step 4:
Install Inner Drawer Chassis. NOTE: Align rear Inner Chasis Bearing with
Flange of Outer Chassis (Figure 5).
Lift Inner Drawer Chassis up to engage “Safety Stop” (Figure 6).
Figure 7
Step 4:
Extend Inner Drawer Chassis to Full open “locked” position and insert
stainless steel Drawer Pan (Figure 7).
Figure 5
Figure 6
NOTE:
When installing on 24” wide Work Tables, use “Front” set of mounting holes.
When installing on 30” & 36” wide Work Tables, use “Rear” set of mounting
holes (Figure 4a & Figure 4b).
24” Work Table
Mounting Holes
30” & 36” Work Table
Mounting Holes
(Figure 4b)
REAR OF DRAWER SHOWN
24” Work Table
Mounting Holes
30” & 36” Work Table
Mounting Holes
(Figure 4a)
FRONT OF DRAWER SHOWN
Inner Chassis
Outer
Chassis