Installation Instructions for SHD Series Drawers

Step 1:

Remove Stainless Steel Drawer Pan and Inner Chassis (See Figure 1).

Step 2:

Align holes of Side Enclosure Panel with holes on top & bottom

ﬂanges of outer Chassis. Insert 1/4 - 20 x 1/2” Bolt into holes and

secure with nuts (Provided). Push rear Flange of Concealed Side

Panel tight against back of SHD Drawer and tighten all bolts

(See Figures 12 & 13).

Step 3:

Reassemble Inner Chassis and Stainless Steel Drawer Pan

(See Figures 5, 6 & 7).

OPTIONAL CONCEALED SIDE PANELS

Contents:

(1) Side Panel

(4) 1/4 - 20 x 1/2” Bolts with Nuts (Per Panel)

Tools Required:

(2) 7/16” Open End Wrenches

1 Drawer:

TA-SHD-1 (Per side)

2 Drawers:

TA-SHD-2 (Per side)

3 Drawers:

TA-SHD-3 (Per side)

Figure 12 Figure 13

NOTE: Panels Are Sold Individually, Not In sets