User's Manual

ManualsBrandsAdvanced Card Systems ManualsElectronicsACR1252

info@acs.com.hk

2013-2-21 www.acs.com.hk

Page 1 of 7

ACR1252 Test Operating Procedure

1. Driver installation Procedure

2. Testing Environment Setup

3. Testing Procedure

Driver installation Procedure

Hardware requires:

 ACR1252

 PC with OS windows XP or above

Software requires:

 Driver “ACS_Unified_PCSC_Driver-4.0.0.0.rar”

Steps:

1. Extract the file “ACS_Unified_PCSC_Driver-4.0.0.0.rar”

2. Run “Setup.exe”

3. Click OK, then “Next>”

Summary of content (7 pages)

PAGE 1
ACR1252 Test Operating Procedure 1. Driver installation Procedure 2. Testing Environment Setup 3. Testing Procedure Driver installation Procedure Hardware requires: ACR1252 PC with OS windows XP or above Software requires: Driver “ACS_Unified_PCSC_Driver-4.0.0.0.rar” Steps: 1. Extract the file “ACS_Unified_PCSC_Driver-4.0.0.0.rar” 2. Run “Setup.exe” 3. Click OK, then “Next>” Page 1 of 7 info@acs.com.hk 2013-2-21 www.acs.com.
PAGE 2
4. Click “Next>”, and install finished: 5. Driver Installation Complete Page 2 of 7 info@acs.com.hk 2013-2-21 www.acs.com.
PAGE 3
Testing Environment Setup Hardware requires: ACR1252 x 1 PC with OS windows XP or above Test card x 1 (provided by ACS) Software requires: APDU.exe Steps: 1. Plug in the reader into the PC 2. Place the Test Card on the top of the reader about 1.5cm Open “APDU.exe” Page 3 of 7 info@acs.com.hk 2013-2-21 www.acs.com.
PAGE 4
3. Select “T1”, “Stress”, Message = “FF CA 00 00 00”, Interval = “500” 4. Press “Connect” 5. Complete the Testing Environment Setup Testing Procedure Hardware requires: ACR1252 x 1 PC with OS windows XP or above Test card x 1 Software requires: APDU.exe Steps: 1. Complete Testing Environment Setup procedure 2. Press “Transmit” to start the testing Page 4 of 7 info@acs.com.hk 2013-2-21 www.acs.com.
PAGE 5
3. The below will be shown 4. Can start to Lab Test Page 5 of 7 info@acs.com.hk 2013-2-21 www.acs.com.
PAGE 6
Appendix A. Parameter sheet Device ACR1252 Smart Card Reader Power supply Supply voltage................................ Regulated 5V DC Supply current ................................ <200mA (without smart card) Universal Serial Bus Interface Type ............................................... USB, four lines: +5V, GND, D+ and DConnector ...................................... supplied together with the reader Speed.............................................
PAGE 7
Standard/Certifications CE, FCC,VCCI, N-Mark OS Windows 2000, XP and up Mac 10.5 and up Linux Android 3.1 and aboveOEM OEM-Logo possible, customer-specific colors, casing, and card connector Revision History Date By 2013-12-20 Edmond Ho Changes • First Release Version 1.00 FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules.