User Manual
LSM-20 Instructions
P/D 112609
LSM-20
by EVOLVE GUEST CONTROLS
4
LED Transmission Indication
The LSM-20 will flicker its LED when it is transmitting to any of its groups. This flickering can be set to not flicker at all (set to 0), to
flicker the entire time it is transmitting (set to 1), or to flicker for only 1 second when it begins transmitting (set to 2). By default, the
LSM-20 is set to flicker for only 1 second.
Each Configuration Parameter can be set to its default setting by setting the default bit in the Configuration Set command. See your controller’s
instructions on how to do this (and if it supports it).
All Configuration commands will be reset to their default state when the LSM-20 is excluded from the Evolve network by using the controller
to reset the node (on the IR-100 select “SETUP” and scroll to “RESET UNIT”).
SUC Support
There must be a Static Update Controller in your Evolve system for this feature to work. The Static Controller can act as a gateway
in the system, since other nodes always know its position (not moved after addition to the network. The “always listening” advantage of the
Static Controller is that other nodes can transmit information frames to it whenever needed.
You can assign an “SUC Route” to the LSM-20. Refer to your controller’s instructions on how to do this (if it supports it). Assigning an SUC
Route to the LSM-20 allows it to request an update of the Evolve devices that are between it and the Evolve device to which it was trying to
transmit. The LSM-20 will only request an update when a transmission fails.
SPECIFICATIONS
Power: 120 VAC, 60 Hz
Signal (Frequency): 908.42 MHz, 9.6Kbps or 40Kbps capable
Maximum Load: Resistive : 20 amps (2400 watts) maximum, 120 VAC
Motor: 1 H.P. maximum, 120 VAC
Incandescent: 960W maximum, 120 VAC
Range: Up to 100 feet line of sight between the Wireless Controller and /or the closest
Evolve Receiver Module
A Evolve™ network can integrate devices of various classes, and these devices can be made by different manufacturers, just as the LSM-20
can be incorporated into existing Evolve™ networks.
The top or bottom of the LSM-20 switch paddle can be used to carry out inclusion (inclusion to the network by adding to a group), as-
sociation (operate simultaneously with other nodes), exclusion (remove from a group) or reset (remove from the network). Controllers
can be replicated in order to provide operation from other locations.