Owner's manual

CP000 Installation Instructions

P/D 022597

ADVANCED CONTROL TECHNOLOGIES, INC.

Indianapolis, Indiana 46278

PCC 120/277 VAC 1:1 Ratio Passive Coupler

BEFORE YOU BEGIN...

READ ALL INSTRUCTIONS

Make sure your installation will conform to all applicable codes and requirements.

TEST FOR SIGNAL STRENGTH AND NOISE...

using the AR300 and AT300. It is necessary to test the installation in the actual operating

environment. The amount and types of line loads may reduce the strength of the transmitted signal

and/or electrical noise may cause interference with the transmitted signal. Proper installation may

require additional couplers, filters or repeaters. Special coupling devices are required to allow signal

to be distributed to all phases and zero-crossings in multi-phase and multi-transformer distributions.

IF YOU HAVE ANY QUESTIONS...

Consult your nearest Engineered System Center (ESC) for additional information.

There are no field repairable assemblies on this unit. It is covered by a two year limited warranty.

If service is needed, the unit must be returned to the ESC where purchased. Contact your ESC for

return details.

INSTALLATION

CAUTION! Make all connections with the POWER OFF to avoid injury to the installer or damage

to the device.

NOTE! The CP000 is designed to transfer command signals generated on one phase of a three

CP000

PAGE 1
CP000 PCC 120/277 VAC 1:1 Ratio Passive Coupler BEFORE YOU BEGIN... READ ALL INSTRUCTIONS Make sure your installation will conform to all applicable codes and requirements. TEST FOR SIGNAL STRENGTH AND NOISE... using the AR300 and AT300. It is necessary to test the installation in the actual operating environment. The amount and types of line loads may reduce the strength of the transmitted signal and/or electrical noise may cause interference with the transmitted signal.
PAGE 2
phase system to one or more of the remaining phases. It will isolate phases from each other to prevent trickle-through of line current from an energized phase to an inert phase. 1. Strip 3/4" of insulation from the ends of the conductors and make connections as shown in the Wiring Diagram. 2. Check connections to be sure they are tight and no bare conductors are exposed. 3. Make sure the load or installation does not exceed the device rating. 4.