Instructions ZTH210 (RF Controller, HandheldLED Indicator, 868.42MHz) Instruction Manual

ZTH200 Operating Instructions (Version 1.26)

P/D 102406

HomePro

by ADVANCED CONTROL TECHNOLOGIES, INC.

SET CONFIG

Allows you to set configuration settings to a unit that supports such functionality. When you select “Set Config”, you

will be prompted with

Consult the instructions that came with the unit you are configuring as to what each parameter number configures.

After selecting parameter number (use the arrow buttons to change parameter number, then press OK), you will be

prompted:

At this point, you will have to again consult the instructions for the unit you are configuring for information on how many

bytes the parameter being set contains. Then press the 1, 2, or 4 button accordingly. At this point you will be

prompted:

Use the arrow buttons to select value, then press OK.

If you have selected 2 or 4 bytes, when asked “# of Bytes” , you will be prompted for ConfigValue 2 and if necessary

ConfigValue3 and ConfigValue4.

After selecting the value(s) you will be prompted to “Press Button On Unit”. Refer to instructions of unit on exactly what

to do in this situation as you may have to do more than simply pressing a button.

After doing so, the ZTH200 will show “Successful” or “Comm. Failed”. If the ZTH200 shows “Comm. Failed”, simply

try again or move closer to unit and try again.

4.6.3 DISPLAY CONTRAST ADJUSTMENT

“C” cancels the contrast adjustment and returns to idle.

Default contrast is 50% which is restored whenever the

batteries have been removed and reinstalled.

4.6.4 SETUP ALL ON/ALL OFF

Using this menu it is possible to customize the way ALL ON/ALL OFF works. Units can be included or

excluded from all on/off commands (refer to instructions of the devices you are controlling to determine if it supports

this feature).