Instructions ZTH210 (RF Controller, HandheldLED Indicator, 868.42MHz) Instruction Manual

ZTH200 Operating Instructions (Version 1.26)

P/D 102406

HomePro

by ADVANCED CONTROL TECHNOLOGIES, INC.

4. HOW TO USE THE ZTH200 FEATURES

4.1 MENU NAVIGATION AND SELECTION

Pushing the “Menu” button will activate the menu display.:

a. and buttons are used to navigate through the menu. All menu levels wrap

around.

b. activates the currently selected menu item and recalls information from thermostat.

c. (or Clear) cancels the currently selected item and will in most instances step back to the

previously selected menu level. If used from top menu level the Controller will return to clock

display.

The top menu level behaves like this: Using the right and left arrow buttons you can toggle right or left through the menu

selections of : GROUPS

SCENES

TIMER

SETUP

THERMOSTAT

Top level menus wrap around, so arrow buttons in any direction will repeat menu selections. Push OK or C button to

activate display if asleep (blank).

Select any one by pressing OK. Follow instructions to set up that function (explained in following paragraphs). Using

the Clear button (C) at any time will take you back to the Time (which will auto-off after 5 seconds).

4.2 GROUPS/SCENES

The layout and behavior of the “groups” and “scenes” menus are very similar. Where they are identical, “groups” is used

as an example. Push OK or C button to activate display if asleep.

To select groups from 7 to 64 or scenes from 7 to 32 see page 28, section 5.5.2 and 5.2.3.