System information

6.14 PTZ Setup

There is one RS-485 port on the DVR rear panel used for PTZ control.

6.14.1 PTZ RS485 Connection

Connect DVR/DVS RS-485 port Pin “T+” with PTZ Pin “A”. Connect DVR RS-485

port Pin “T-“ with PTZ Pin “B”. If DVR RS-485 port is an RJ45 interface, please

refer to DVR user manual for the RS-485 pin definition.

6.14.2 PTZ Settings

Configure the RS-485 parameters to match your PTZ protocol. In the main menu,

select the PTZ setup option.

PTZ menu Options:

•Select channel: Select a PTZ camera.

•RS-485 parameters: Including baud rate, data bit, stop bit, parity, flow control, etc.

These parameters must be the same as those required by the PTZ protocol.

•PTZ address: Each PTZ has a different address.

•PTZ type: The DVR has the following PTZ protocols:

YouLi, LinLin-1016, LinLin-820, Pelco-p, DM DynaColor,

HD600, JC-4116, Pelco-d WX, Pelco-D, VCOM VC-2000,

NetStreamer, SAE/YAAN, Samsung, Kalatel-312, CELOTEX,

TLPelco-p, TLHHX-2000, BBV, RM110, KC3360S,

ACES, ALSON, INV3609HD, Howell, Tc Pelco P,

Tc Pelco D, AUTO-M, AUTO-H, ANTEN, CHANGLIN,

DeltaDome, XYM-12, ADR8060, EVI-D30, DEMO-SPEED,

DM-PELCO-D ST832, LC-D2104, HUNTER, A01,

TECHYIN, WEIHAN, LG, D-MAX, Panasonic,

KTD-348, infinova, PIH-7625, LCU, DennarDome,

VICON, TKC676, YAAN_NEW DL_NVS_1Z, i3DVR.

Other PTZ protocols will be added with the new firmware.

Note: If you select Pelco-P protocol set the dome address one number higher than the

DVR setting. For example, if camera ID is 2, the DVR PTZ address is set as ID 3.