User Manual

AirFusion™ Inatable Kayak Owner’s Manual
11
7. Install pole #2 into the rear end of the kayak, connecting it with the boom portion of the
Stern Rib. The pole should be on top of the foam oor and the numbered end of the pole
should be at the cockpit of the kayak. See Figure 7.
Figure 7
a. Tip: Connect pole #2 with the Stern Rib through the zipper on the deck at the rear end
of the kayak.
8. Slide Locking Sleeve #3 over the end of pole #2 (at the cockpit position), making sure the hole
for the snap buon is facing the free end of pole #2. See Figure 8.
Figure 8
9. Connect poles #1 and #2 together by liing each pole upwards and joining the ends together
and then pushing them downwards, this will require a lile force and will push the Bow
and Stern Ribs into place, stretching the kayak out to its full length. Immediately aer poles
#1 and #2 are connected, slide Locking Sleeve #3 over pole #1 until the connection point of
Rear zipper
access
Stern Rib
Pole #2