User guide

111
6 WHT 10
2. Verify that the 430W Configuration is correct
a. Main ARINC 429 CONFIG
Power up the 430W while holding the ENTER button and press
[ENT] -> [ENT] to get to the Main ARINC 429 Config page.
Verify that the screen looks correct.
b. Serial Ports
Turn the inside right knob to configure the MAIN RS232 CONFIG
to the following settings
Note: Serial port selections shown are specific to the AFS schematic
found in the rear of this manual.
c. VOR/LOC/GS ARINC 429 CONFIG
Turn the inside right knob around 14 clicks to configure the
VOR/LOC/GS ARINC 429 to the following settings.
3. Verify that the 430W GPS ARINC to EFIS interface is working
The 430W must be running software version 3.30 or later or you will not get a CDI needle
displayed!
a. Verify that the 430W is selected as the EFIS NAV source from the following menu:
EFIS -> NAVIGATION -> CRS/GNAV1
The course needle should be set to CRS/GNAV1
b. Turn on the 430W and select the Instrument Test Page, second
startup page (press ENTER once after power up).
Verify that the 430W is not in VLOC mode for this test. The 430W
will power up in the last mode selected.
Verify that the EFIS CDI, VDI, and WPID all look like
this screen:
WPID: GARMN
CDI Half Left
VDI Half Up
If the CDI, VDI, and WP ID are correct move to Step
4.