User guide

25
TAWS Settings
Instrument Calibration: 35: Synthetic Vision
3. Terrain Warning (TAWS) ON/OFF - Enables/Disables terrain shading based on altitude
4. TAWS Airspeed Shutoff (KTS) - Sets the airspeed at which TAWS is disabled (for landing).
Traffic Display
If a traffic device is connected to your EFIS monitor, the traffic will be displayed on the SVN. Traffic shown
must be within 6nm of your aircraft and within the 60 degree view cone of the SVN 30 degrees on either side
of your current heading).
Example:
The top down map may show traffic in 360 degree directions around you and could be 25nm ahead of
you. However traffic depicted on SVN is limited to 6nm in range and 30 degrees on either side of your aircrafts
heading.
Traffic depicted on SVN is similar to the map view, but with only 2 symbol possibilities. Since all traffic shown
will be within 6nm, we don't display the diamond with a square inside of it.
Proximity Traffic (within 1200ft relative altitude and less than 6nm range)
Traffic Advisory (within 1200ft relative altitude and less than 0.2nm range)
Obstacle Display
SVN shares the same obstacle database as the top-down map page. Obstacles are shown at their proper
height above ground and at their bases are drawn at half of their height.
There are several exclusions users will want to be aware of:
- Obstacles beyond 18nm are not shown
- Obstacles less than 1000ft AGL are not shown beyond 6nm
- Obstacles more than 2,000ft AGL below the aircraft are not shown
RED: Aircraft is within 100ft AGL of top of tower
YELLOW: Aircraft is within 600ft AGL of top of tower
GRAY: Aircraft is within 2000ft AGL of top of tower.