User guide

74
External Device Configuration
AF-ARINC 429 ADAPTOR
The AF-ARINC adaptor provides 2 serial inputs for display of navigation data (VOR, ILS, GPS, LPV ) from a
Garmin 430W/530W/480 and 1 serial output. The ARINC 429 output can be connected to multiple ARINC
429 receivers; 430W, 530W, 480, and Autopilots that support GPS steering commands. The AF-ARINC
module should be connected to EFIS Serial Port #3 or Serial Port #4.
For ARINC module wiring information see APPENDIX M, drawing number: 53620WD
CO Guardian Display
Currently, the new “s” mode processor will display data from any
of the CO Guardian units that support RS-232 MFD output. The
current cabin CO level is displayed on any of the Check List
pages. If the CO Guardian device generates a warning, the
current CO level will be displayed as a pop up message on the
EFIS screen. If you have the new Aero-455 (CO, heart rate, O2
level ) monitor, the data will be displayed as a pop up message
after about 20 seconds of monitoring you finger. The CO
Guardian should be wired to any open serial port and then the
serial port Admin setting set to CO Guardian.
Garmin 430W/530W
The 430W/530W should be wired for RS-232 Aviation format to serial port #1 along with their ARINC lines
connected to the AF-ARINC module. See APPENDIX M, drawing number: 53620WD
EFIS Main Cable 430W RS-232 Connection
Pin 10 TXD --------------- 4001-57 RX
Pin 22 RXD --------------- 4001-56 TX
The 430W/530W needs the following software configuration settings:
1. MAIN ARINC 429 CONFIG
Power up the 430W while holding the ENTER button and press
[ENT] -> [ENT] to get to the Main ARINC 429 Config page.
Configure the 430W using these settings. OUT must be set to
GAMA 429.
2. VOR / LOC / GS ARINC 429 CONFIG
Turn the inside right knob around 14 clicks to configure the
VOR/LOC/GS ARINC 429 to the following settings.
3. Serial Ports
Select ARNAV/ei-fuel for the input and Aviation as the output.