User guide

Pressure Transducer Installation

Firewall Installation using Van’s P/N: VA-168, 3-port manifold

mounting block.

Oil Pressure Transducer Installation

Mount the oil pressure transducer in a stationary location.

Connect the transducer with aircraft grade hose and fittings.

You can find the proper oil pressure connecting port in your

engine manual. Your engine must have a pressure fitting

with a restrictor hole in it. The transducer is supplied with

1/8” NPT pipe thread connections. The case of the sender

has to be connected to ground. The Oil Pressure transducer wire should be connected from the harness to

the transducer by crimping a standard #8 ring terminal to the wire.

Pin 6 White/Yellow

NOTE: The pressure rating (100psi or 10bar 150psi) can be found stamped on the bottom hex fitting

of the transducer

P/N Pressure Manufacturer Color Terminal

41,105 0-100 PSI Stewart Warner Gold #8 Ring

41,115 0-150 PSI (10 bar) VDO Silver #8 Ring

CAUTION: NEVER CONNECT THE PRESSURE TRANSDUCER DIRECTLY TO THE ENGINE.

Fuel Pressure Transducer Installation

Mount the fuel pressure transducer to a stationary location. Connect the transducer with aircraft grade hose

and fittings. You can find the proper fuel pressure connecting port in your engine manual. Your engine

must have a pressure fitting with a .040” or smaller restrictor hole in it, this prevents the fuel pump

pulsations from damaging the transducer and will slow the flow of fuel if a hose were to fail. The transducer is

supplied with 1/8” NPT pipe thread connections. The case of the sender has to be connected to ground.

The Fuel Pressure transducer wire should be connected from the harness to the transducer by crimping a

standard #8 ring terminal to the wire.

If you are using the P/N: 41,215 (0-30 PSI) transducer you will need to use a ¼” Fast-On terminal for the

transducer wire and a separate ground wire connected to the second terminal. It does not matter which

terminal is used for the sensor wire or ground wire.

Pin 8 Brown

NOTE: The pressure rating can be found stamped on the bottom hex fitting of the transducer

Carbureted Engines

P/N Pressure Manufacturer Color Terminal

41205 0-16 PSI Stewart Warner Gold #8 Ring

41215 0-30 PSI (2 bar) VDO Silver ¼” Fast-On (Signal & GND)

Fuel Injected Engines

P/N Pressure Manufacturer Color Terminal

41305 0-60 PSI Stewart Warner Gold #8 Ring

41315 0-80 PSI (5 bar) VDO Silver #8 Ring